States ›New York ›Oneida County ›Annsville

Annsville, NY Tap Water Quality 2026

Water quality report for Annsville, NY — PFAS, lead and copper results, violation history and state inspection findings from EPA SDWIS.

A look at Annsville's drinking water using EPA enforcement records: violations, lead and copper results, PFAS sampling and state inspection findings.

Main Utility: Taberg Water Districts (1 & 75) PWSID: NY3202409 Updated: 2026 Q2
✅

No federal limits exceeded on record

Lead is 1.60 ppb, 11% of the action level and no violations are open. PFAS has never been sampled at this system.

B

Annsville earns a B for water quality

Graded on violations and lead, with state inspection findings. PFAS not tested.

Lead: 1.60 ppb — 11% of the federal action level
PFAS never sampled at this system
1 violations since 2015, 0 health-based
No violations currently open
Annsville's lead level vs. all New York community water systems
0 ppb5 ppb10 ppb15 ppb
Lead level: 1.60 ppb — 11% of the federal action level
✓ Lower lead than 71% of New York utilities
Population Served
287
~195 connections
Water Source
Surface water
Purchased from another system — SDWIS source code SWP
Active Violations
0
1 since 2015, all resolved

Lead & Copper Testing

Lead (Pb)
90th percentile of tap samples collected across the distribution system
11% of EPA action level
1.60 ppb
Action level: 15 ppb
The 90th-percentile lead result is 1.60 ppb, 11% of the 15 ppb federal action level. The action level is a treatment trigger, not a legal maximum, and it is measured across sampled taps rather than at any single home.

Contaminant Violations (2015–Present)

ContaminantTypeMeasuredLimitPeriodStatus
Revised Total Coliform Rule MONITORING FAILURE — — 2024 Resolved
Understanding violation types MCL violations mean a contaminant exceeded the federal maximum limit — the most serious type.
TT (Treatment Technique) violations mean required treatment procedures weren't followed, but don't necessarily mean contamination occurred.

Violation History

1 violations are on record since 2015, of which 0 were health-based. All have been resolved and none remain open.

About the Main Water System

Utility Taberg Water Districts (1 & 75)
PWSID NY3202409
Water source Surface water — Purchased from another system — SDWIS source code SWP
Population served 287
Service connections 195
Systems serving this area 3
Regulator State primacy agency
Data through 2026 Q2 — EPA SDWIS

Frequently Asked Questions

Is Annsville tap water safe to drink? ▼
No federal limit is exceeded on record. No violations are currently open. Lead is 1.60 ppb, 11% of the action level.
Does Annsville water have PFAS? ▼
This system has never been sampled for PFAS. EPA's national monitoring covered systems serving 3,300 people or more, so no results exist — which is not evidence that none is present.
Who supplies water to Annsville? ▼
Taberg Water Districts (1 & 75) (PWSID NY3202409), one of 3 systems serving this area. Surface water. Purchased from another system — SDWIS source code SWP
When was this system last inspected? ▼
It was last inspected on 2023-03-30. No significant deficiencies were recorded.

What Should Annsville Residents Do?

1
Read your annual water report
Your supplier publishes a Consumer Confidence Report each July covering the prior year.
2
Check for a lead service line
Lead reaches tap water mainly through service lines and household plumbing. Suppliers now publish an inventory identifying lead lines.
3
Flush before drinking
If water has sat in pipes more than six hours, run the cold tap for two minutes before drinking or cooking.

Nearby Cities in New York

Utica, Ny Tap Water Quality 2026 Oneida Rome, Ny Tap Water Quality 2026 Oneida New Hartford, Ny Tap Water Quality 2026 Oneida Whitestown, Ny Tap Water Quality 2026 Oneida Marcy, Ny Tap Water Quality 2026 Oneida Vienna, Ny Tap Water Quality 2026 Oneida