States ›Washington ›Yakima County ›Yakima

Yakima, WA Tap Water Quality 2026

Water quality report for Yakima, WA — PFAS, lead and copper results, violation history and state inspection findings from EPA SDWIS.

A look at Yakima's drinking water using EPA enforcement records: violations, lead and copper results, PFAS sampling and state inspection findings.

Main Utility: Yakima Water Division City Of PWSID: WA5399150 Updated: 2026 Q2
✅

No federal limits exceeded on record

Lead was not detected and no violations are open. No PFAS was detected.

A

Yakima earns an A for water quality

Graded on violations, lead, and PFAS, with state inspection findings.

Lead: not detected
PFAS tested, none detected
3 violations since 2015, 0 health-based
No violations currently open
Yakima's lead level vs. all Washington community water systems
0 ppb5 ppb10 ppb15 ppb
Lead level: Not detected — 0% of the federal action level
✓ Lower lead than % of Washington utilities
Population Served
69060
~29737 connections
Water Source
Surface water
Drawn from surface water — SDWIS source code SW
Active Violations
0
3 since 2015, all resolved

Lead & Copper Testing

Lead (Pb)
90th percentile of tap samples collected across the distribution system
0% of EPA action level
Not detected
Action level: 15 ppb
Copper (Cu)
90th percentile of tap samples. SDWIS reports a copper figure only when a system exceeds the action level, so any value here is an exceedance.
123.1% of EPA action level
1,600 ppb
Action level: 1,300 ppb
Lead was not detected at the 90th percentile — the result fell below the laboratory detection limit. That is not the same as an absence of lead in every tap, and older homes with lead service lines can still show higher readings. Copper reached the action level here; a copper figure appears in SDWIS only when a system triggers it.

Contaminant Violations (2015–Present)

ContaminantTypeMeasuredLimitPeriodStatus
Consumer Confidence Rule OTHER — — 2024 Resolved
Nitrate MONITORING AND REPORTING — 10 mg/L 2020 Resolved
Consumer Confidence Rule OTHER — — 2016 Resolved
Understanding violation types MCL violations mean a contaminant exceeded the federal maximum limit — the most serious type.
TT (Treatment Technique) violations mean required treatment procedures weren't followed, but don't necessarily mean contamination occurred.

Violation History

3 violations are on record since 2015, of which 0 were health-based. All have been resolved and none remain open.

About the Main Water System

Utility Yakima Water Division City Of
PWSID WA5399150
Water source Surface water — Drawn from surface water — SDWIS source code SW
Population served 69,060
Service connections 29,737
Systems serving this area 5
Regulator State primacy agency
Data through 2026 Q2 — EPA SDWIS

Frequently Asked Questions

Is Yakima tap water safe to drink? ▼
No federal limit is exceeded on record. No violations are currently open.
Does Yakima water have PFAS? ▼
It was tested for the six regulated PFAS compounds and none were detected.
Who supplies water to Yakima? ▼
Yakima Water Division City Of (PWSID WA5399150), one of 5 systems serving this area. Surface water. Drawn from surface water — SDWIS source code SW
When was this system last inspected? ▼
It was last inspected on 2023-08-03. No significant deficiencies were recorded.

What Should Yakima Residents Do?

1
Read your annual water report
Your supplier publishes a Consumer Confidence Report each July covering the prior year.
2
Check for a lead service line
Lead reaches tap water mainly through service lines and household plumbing. Suppliers now publish an inventory identifying lead lines.
3
Flush before drinking
If water has sat in pipes more than six hours, run the cold tap for two minutes before drinking or cooking.

Nearby Cities in Washington

Sunnyside, Wa Tap Water Quality 2026 Yakima Grandview, Wa Tap Water Quality 2026 Yakima Toppenish, Wa Tap Water Quality 2026 Yakima Terrace Heights, Wa Tap Water Quality 2026 Yakima Selah, Wa Tap Water Quality 2026 Yakima Union Gap, Wa Tap Water Quality 2026 Yakima