Luverne, MN Tap Water Quality 2026

Water quality report for Luverne, MN — PFAS, lead and copper results, violation history and state inspection findings from EPA SDWIS.

A look at Luverne's drinking water using EPA enforcement records: violations, lead and copper results, PFAS sampling and state inspection findings.

Main Utility: Luverne PWSID: MN1670004 Updated: 2026 Q2

✅

No federal limits exceeded on record

Lead is 5.00 ppb, 33% of the action level and no violations are open. PFAS was sampled but not enough times for a compliance determination.

Luverne earns a B for water quality

Graded on violations and lead, with state inspection findings. PFAS not tested.

Lead: 5.00 ppb — 33% of the federal action level

PFAS sampled, too few results to judge

2 violations since 2015, 0 health-based

No violations currently open

Luverne's lead level vs. all Minnesota community water systems

0 ppb5 ppb10 ppb15 ppb

Lead level: 5.00 ppb — 33% of the federal action level

✓ Lower lead than 16% of Minnesota utilities

Population Served

4930

~2041 connections

Water Source

Groundwater

Drawn from wells — SDWIS source code GW

Active Violations

2 since 2015, all resolved

Lead & Copper Testing

Lead (Pb)

90th percentile of tap samples collected across the distribution system

33% of EPA action level

5.00 ppb

Action level: 15 ppb

Copper (Cu)

90th percentile of tap samples. SDWIS reports a copper figure only when a system exceeds the action level, so any value here is an exceedance.

110.8% of EPA action level

1,440 ppb

Action level: 1,300 ppb

The 90th-percentile lead result is 5.00 ppb, 33% of the 15 ppb federal action level. The action level is a treatment trigger, not a legal maximum, and it is measured across sampled taps rather than at any single home. Copper reached the action level here; a copper figure appears in SDWIS only when a system triggers it.

Contaminant Violations (2015–Present)

Contaminant	Type	Measured	Limit	Period	Status
Revised Total Coliform Rule	MONITORING FAILURE	—	—	2018	Resolved
Chlorine	MONITORING AND REPORTING	—	4.0 mg/L	2018	Resolved

Understanding violation types MCL violations mean a contaminant exceeded the federal maximum limit — the most serious type.
TT (Treatment Technique) violations mean required treatment procedures weren't followed, but don't necessarily mean contamination occurred.

Violation History

2 violations are on record since 2015, of which 0 were health-based. All have been resolved and none remain open.

About the Main Water System

Utility Luverne

PWSID MN1670004

Water source Groundwater — Drawn from wells — SDWIS source code GW

Population served 4,930

Service connections 2,041

Systems serving this area 2

Regulator State primacy agency

Data through 2026 Q2 — EPA SDWIS

Frequently Asked Questions

Is Luverne tap water safe to drink? ▼

No federal limit is exceeded on record. No violations are currently open. Lead is 5.00 ppb, 33% of the action level.

Does Luverne water have PFAS? ▼

It was sampled, but no sampling point had enough results for a compliance determination.

Who supplies water to Luverne? ▼

Luverne (PWSID MN1670004), one of 2 systems serving this area. Groundwater. Drawn from wells — SDWIS source code GW

When was this system last inspected? ▼

It was last inspected on 2025-05-13. No significant deficiencies were recorded.

What Should Luverne Residents Do?

Consider a filter certified for lead

Look for NSF/ANSI 53 certification for lead reduction.

Check for a lead service line

Lead reaches tap water mainly through service lines and household plumbing. Suppliers now publish an inventory identifying lead lines.

Flush before drinking

If water has sat in pipes more than six hours, run the cold tap for two minutes before drinking or cooking.

Nearby Cities in Minnesota

Hills, Mn Tap Water Quality 2026 Rock Luverne, Mn Tap Water Quality 2026 Rock Martin, Mn Tap Water Quality 2026 Rock Beaver Creek, Mn Tap Water Quality 2026 Rock Beaver Creek, Mn Tap Water Quality 2026 Rock Kanaranzi, Mn Tap Water Quality 2026 Rock