States ›Minnesota ›Brown County ›Milford

Milford, MN Tap Water Quality 2026

Water quality report for Milford, MN — PFAS, lead and copper results, violation history and state inspection findings from EPA SDWIS.

A look at Milford's drinking water using EPA enforcement records: violations, lead and copper results, PFAS sampling and state inspection findings.

Main Utility: New Ulm PWSID: MN1080003 Updated: 2026 Q2
✅

No federal limits exceeded on record

Lead is 2.00 ppb, 13% of the action level and no violations are open. No PFAS was detected.

A

Milford earns an A for water quality

Graded on violations, lead, and PFAS, with state inspection findings.

Lead: 2.00 ppb — 13% of the federal action level
PFAS tested, none detected
2 violations since 2015, 0 health-based
No violations currently open
Milford's lead level vs. all Minnesota community water systems
0 ppb5 ppb10 ppb15 ppb
Lead level: 2.00 ppb — 13% of the federal action level
✓ Lower lead than 83% of Minnesota utilities
Population Served
~5457 connections
Water Source
Groundwater
Drawn from wells — SDWIS source code GW
Active Violations
0
2 since 2015, all resolved

Lead & Copper Testing

Lead (Pb)
90th percentile of tap samples collected across the distribution system
13% of EPA action level
2.00 ppb
Action level: 15 ppb
Copper (Cu)
90th percentile of tap samples. SDWIS reports a copper figure only when a system exceeds the action level, so any value here is an exceedance.
107.7% of EPA action level
1,400 ppb
Action level: 1,300 ppb
The 90th-percentile lead result is 2.00 ppb, 13% of the 15 ppb federal action level. The action level is a treatment trigger, not a legal maximum, and it is measured across sampled taps rather than at any single home. Copper reached the action level here; a copper figure appears in SDWIS only when a system triggers it.

Contaminant Violations (2015–Present)

ContaminantTypeMeasuredLimitPeriodStatus
Revised Total Coliform Rule MONITORING FAILURE — — 2021 Resolved
Chlorine MONITORING AND REPORTING — 4.0 mg/L 2021 Resolved
Understanding violation types MCL violations mean a contaminant exceeded the federal maximum limit — the most serious type.
TT (Treatment Technique) violations mean required treatment procedures weren't followed, but don't necessarily mean contamination occurred.

Violation History

2 violations are on record since 2015, of which 0 were health-based. All have been resolved and none remain open.

About the Main Water System

Utility New Ulm
PWSID MN1080003
Water source Groundwater — Drawn from wells — SDWIS source code GW
Population served
Service connections 5,457
Systems serving this area 1
Regulator State primacy agency
Data through 2026 Q2 — EPA SDWIS

Frequently Asked Questions

Is Milford tap water safe to drink? ▼
No federal limit is exceeded on record. No violations are currently open. Lead is 2.00 ppb, 13% of the action level.
Does Milford water have PFAS? ▼
It was tested for the six regulated PFAS compounds and none were detected.
Who supplies water to Milford? ▼
New Ulm (PWSID MN1080003). Groundwater. Drawn from wells — SDWIS source code GW
When was this system last inspected? ▼
It was last inspected on 2023-10-25. No significant deficiencies were recorded.

What Should Milford Residents Do?

1
Read your annual water report
Your supplier publishes a Consumer Confidence Report each July covering the prior year.
2
Check for a lead service line
Lead reaches tap water mainly through service lines and household plumbing. Suppliers now publish an inventory identifying lead lines.
3
Flush before drinking
If water has sat in pipes more than six hours, run the cold tap for two minutes before drinking or cooking.

Nearby Cities in Minnesota

New Ulm, Mn Tap Water Quality 2026 Brown Sleepy Eye, Mn Tap Water Quality 2026 Brown Springfield, Mn Tap Water Quality 2026 Brown Comfrey, Mn Tap Water Quality 2026 Brown Hanska, Mn Tap Water Quality 2026 Brown Evan, Mn Tap Water Quality 2026 Brown